Gas Fireplace Venting options

Power Vent and Direct Vent Options

Note: This page is for general information only. Please consult specific model manuals for venting requirements and clearances.

THE TOWN & COUNTRY POWER VENT SYSTEM
INDOOR GAS FIREPLACES

Our optional power venting allows venting to run up to 110 feet from an outside wall or roof surface and reach almost any room or commercial setting. It allows you to vent horizontally or vertically with up to six 90-degree elbows, including runs up to 3 feet below the fireplace*.
* with specific variations for the TC54 and TCWS54 See-Thru Indoor/Outdoor

The premium Power Vent fan runs quietly outside, at the external terminal.

Not for use with outdoor gas fireplaces.

See your local Town & Country retailer or consult the power vent instructions for more information.

Power Vent

 

REVOLUTIONARY VARIABLE DEPTH POWER VENT WITH SMART CHIP TECHNOLOGY

Power Vent

Available only with the Town & Country power vent system, our new horizontal power vent system sits perfectly flush with the outside wall and is fully adjustable to accommodate a variety of surfaces. New Smart chip technology allows the Electronically Commuted Motor (ECM) to provide constant airflow regardless of changing static pressure conditions caused by air heating while adjusting speed and torque automatically to maintain designed air volumes. Reduced noise, increased efficiency, and low operating temperature to extend the life of the motor make it one of the most effective Power Vent systems on the market.

Choose from two configurations:
Runs 1 to 25 feet
Runs 7 to 100 feet

Not for use with TC54.

IMPORTANT: Use varies with model. See you local retailer and installation manual for more information.

Variable Depth Power Vent Manual Download

 

Power vent termination for roof installation

*Not for use with TC54 and TCWS54 See-Thru Indoor/Outdoor

Download the manual

TC54 high capacity power vent

High capacity power venting delivers extra venting versatility exclusively for the TC54. This power vent requires 8 x 11 pipe.

Download the manual

DIRECT VENT TERMINATIONS
INDOOR + OUTDOOR GAS FIREPLACES

Standard 8 x 11 coaxial venting with vertical or horizontal termination.
This is the standard venting for Series D, Series C, and Series B models

Stainless steel vent terminal

Town & Country's stainless steel vent terminal provides a solution for high elevation or hard-to-reach locations on large or multi-story buildings. The two-phase installation allows the sleeve to be installed during the construction phase, while the terminal can be installed from inside the structure when the fireplace is installed. The terminal's hardy, stainless steel construction is crafted to withstand wetter or harsher climates.

Download the manual
*Not for use with TC54, TCWS54 See-Thru, TCWS54 See-Thru Indoor/Outdoor

Standard Direct Vent Termination for wall installation

Please refer to unit manuals for instructions.


*Not for use with TC54, TCWS54 See-Thru, TCWS54 See-Thru Indoor/Outdoor

Standard Direct Vent Termination for roof installation

Please refer to unit manuals for instructions.

 

*Not for use TCWS54 See-Thru, TCWS54 See-Thru Indoor/Outdoor

Please note: Due to elevation and fuel type, flame characteristics may not be exactly as shown.